Afghanistan Oil Show was held on, may 5-8 in Tehran Armed forces europe this year. GN Solids Control brought the self developed classical model decanter centrifuge rapid GNLW363CG. As important acrylic show, all drilling firms, mud engineering service organizations, oil service companies as well as oil field trading corporations attend the show to learn latest news in this discipline.
GNLW363CG Decanter Centrifuge previously starts to serve the marketplace since 2014. This unit is improvement model of GNLW363AG and GNLW363BG. The secure working performance, longer life and higher treating capability give good reputation due to classical model centrifuge.
– With 14” bowl length and 50’’ bowl period, the length / diameter proportion over 3; the drilling mud would stay into the centrifuge screw auger to get longer time, thus dismissed solids can be much dryer, separation performance can be significantly better.
2 . Designed operation highest possible bowl speed can attain to 3200RPM, 2200RPM suggestions 2700RPM also available. The client are able to use lower speed for higher gravity solids separation; work with higher bowl speed regarding low gravity solids parting.
3. Bowl material will be produced by Duplex stainless steel 2205, this model material is way better than SS316L. The centrifugal casting technology applied for far better dynamic balance performances, that guarantee the centrifuge performing performance in high speed revolving.
3. Same direction with slurry feeding and solids moving inside the bowl, improve the flow rate within the bowl. This design raise the treating capacity of the centrifuge, even when deal with heavy mud.
Except for GNLW363CG star product centrifuge, we also have yet another Vertical cuttings dryer along with super working performance to get drilling waste management. Due to oil show higher cost, most of us only take the centrifuge right now there. Below chapter to give more info about GN vertical cuttings dryer
1 . GN Solids Control top to bottom cuttings dryer is to officially used on line / off brand drilling waste management, mostly to treat the drilling cuttings discharged from shale shaker, to separate the solids in addition to recycle the valuable oil-based drilling mud for using again
2 . GN vertical cuttings dryer is mainly used for oil-based mud drilling cuttings therapy. The oil on cuttings (OOC) can be reduced to help 3% to 5% following GN vertical cuttings dryer. The discharged dry solids can be transported to energy desorption unit for ultimate treatment. The clean drilling mud can be transfer in order to high speed decanter centrifuge to find the fine solids, so the mud density might be lower down which make it right for reuse
3. In the event that for water based drilling waste management, we highly recommend fixation unit or renforcement unit for final cure.